Raven viper 4+ - Wire Routing and Harness Installation

10
Secon 5 Mapping with a Viper
Mapping is best done by antenna posion. Change to
the Mobile Mapping conguraon before you start
mapping. Hit the current machine icon (top le), or if
the Mobile Mapping conguraon is already selected
skip ahead to Start your mapping Job (see below)
Choose the Mobile Mapping conguraon to highlight
the icon.
Hit the start buon on the boom right.
Start your mapping Job
Make sure you have the correct tractor selected.
Make sure your GPS icon is green (if you just changed
tractors it will take a few minutes to reset)
Click Start Job icon
Turux recommends leaving the generic name in the
Job Name eld for any mapping jobs. It is not important
to save these jobs, you only need the eld boundaries
you create with these jobs.
Click green triangle buon to begin.
You should be back to main screen
Touch scout group widget