Raven viper 4+ - Page 12

12
While recording your widget changes to a stop, pause
buon.
You can pause at any point on the boundary you are
making and then restart again at a point further along
the boundary. Restarng will create a straight line from
the point where you paused and the point where you
restart.
If you want to create a long straight line it is be best to
start with that line by hing record and then pause at
your start point, eecvely recording a point, then
drive to the end point of your long line to and hit
record. Drive from there to create the rest of the
boundary.
At the end of making your boundary stop short of your
start point and hit Save (The icon with a diskee)
Once the boundary is completed, the record icons
disappear and you will see the Scout Group icon on the
screen again.
If you want to create more boundaries, touch the Scout
Group icon and connue back on the “Naming each
boundary” step above.
If you are nished with mapping:
Hit the Home icon on the boom right of the screen
Hit End Job (Red Buon) to end your mapping job.
Note: If you are nished mapping and
going to be spraying you need to change
the Machine Conguraon back to your
sprayer.