RAWLINK 68675 - Compressor; Lamp; Storage; Cleaning and maintenance

34
GB
13.Replaceitonthestartbooster.
14.Setthestartboostertochargeassoon
as possible.
Compressor
Do not use the compressor for more than
ten minutesatatime.Allowthecompres-
sortocooldownforabout30minutes
before using it again.
The start booster is delivered with
compressedairtubeswithaxedtube
nozzle(11)andthreeextrapumpnozzles:
• Usethexednozzleforcartyres.
• Usetheneedleforleatherballs.
• Usetheplasticnozzleforothertypesof
ball or other plastic or rubber items.
1. Fitthenozzletobeused,andapplythe
nozzletotheobjecttobeinated.
Attachthenozzletothettednozzleor
the valve of the tyre by pressing down
thearmonthemouthpiece(gure4).
5. Detachanyextranozzleandturnothe
start booster.
Lamp
Thelamp(2)canbeusedaslightingfor
work or in emergencies.
• Thelampcanbeturnedonoroby
pressingtheon/oswitch(9).
Switchthelampowhennotinuse.
Storage
The start booster should be stored fully
chargedtomaintainmaximumbattery
lifetime.
Remembertochargethebatteryevery
three to ve months, regardless of whether
it has been used or not.
Because the battery is sealed, there is no
risk of leakage, and your start booster can
therefore be stored and transported in any
position.
Cleaning and maintenance
Duringmaintenance,theon/oswitch(10)
MUST be in the OFF position.
The start booster and battery are
maintenancefree.Cleanthestartbooster
with a damp cloth if necessary. Do not use
corrosive or abrasive cleaning agents.
2. Turnonthecompressorbymeansofthe
on/oswitch(12)inpositionI.
3. Keepaneyeonthepressuregauge(13)
during pumping!
4. Turnothecompressorbyippingthe
on/oswitchtoposition0whenthe
required pressure has been reached.