28
GB
Secure the curved end of the lifting arm (2)
to the door bracket and secure the other
end to the rider inside the rail.
Pull the cord secured to the rider so that the
brake is released.
Open and close the door by hand to check
that all the parts move correctly and do not
stick.
The door opener must be programmed
before it can be used.
Connect the door opener to the mains
electricity.
Press and hold the SET button until “1”
appears in the display.
Adjust the open position for the door by
pushing the UP button and then fine-tuning
the position using the UP and DOWN
buttons.
Press the SET button so “2” appears in the
display.
Adjust the closed position for the door by
pushing the DOWN button and then fine-
tuning the position using the UP and DOWN
buttons.
Press the SET button.
The positions and the opening and closing
resistance are saved in the memory.
To Next Page
Loading...