RAWLINK ET-800C - Page 29

29
NO
SE
FI
GB
DE
DK
PL
ET

Press and hold the CODE button until the
dot appears in the display.
Press one of the buttons on the remote
control once.
The dot disappears from the display.
Press one of the buttons on the remote
control again.
The dot in the display flashes and “11”
appears in the display.
The remote control is now registered.
You can deregister any registered remote
controls by pressing and holding the
CODE button for at least 8 seconds until “C”
appears in the display.

Press and hold the SET button until “3”
appears in the display.
Adjust the resistance from 1 (minimum)
to 9 (maximum) using the UP and DOWN
buttons.
Press the SET button to save the setting.

Press and hold the UP button until “-”
appears in the display.
Adjust the time for automatic closing from
0 to 9 minutes using the UP and DOWN
buttons.
At 0 minutes, automatic closing is turned
off.
Press the SET button to save the setting.