30
GB
The door is opened and closed and the light
turned on and off using the remote control.
In the event of a power failure, you can
open or close the door manually.
Pull the cord that is attached to the rider in
the rail to release the brake.
When the power comes back on, you can
use the door opener normally again.
The surfaces of the door opener must be
brushed down or wiped with a well-wrung
cloth.
If the door opener starts to make abnormal,
squeaking or rattling noises, lubricate all
moving parts and, if necessary, tighten the
chain.
1) The chain runs in the rail, but the door
does not move.
The brake on the rider has been
released. Engage the brake.
2) The door stops suddenly or moves
jerkily.
The door has encountered an obstacle.
Remove the obstacle, and let the door
run a full cycle (right up, right down,
right up) to get it back to normal
operation.
The model number is shown on the front of
this manual and on the product rating plate.
For:
• Complaints
• Replacements parts
• Returns
• Guarantee issues
• Open weekdays from 07.00 to 17.00
(Fridays until 15.30)
• E-mail: service@hpschou.com
To Next Page
Loading...