RG165T-R Operator · Service · Maintenance
800.392.2686
49
Cutter Wheel Bearings
Lubricate
Lubricate the cutter wheel bearings zerk(1) fitting DAILY. Fill
with high-temperature (NLGI 2) grease until you can visually
see the old grease purge itself out all the way around the seal
diameter and new grease beginning to purge out.
This will ensure that the dirt and debris that gets collected
inside the seal area is flushed away from the internal bearings
thus providing longevity to the bearing and races.
Engine Leaks - Check
Check for leaks as described in the “After First 50 Hours”
interval of the Cummins Engine Operation Manual.Engine
Mounts - Check
Check and tighten if necessary all engine mounts.
Maintenance
1
INSERT GREASE SLOWLY AND CAREFULLY TO
PREVENT DAMAGE TO THE BEARING SEALS. USE
EXTRA CAUTION WHEN USING A HIGH PRESSURE
OR HIGH VOLUME GREASE GUN.
1
To Next Page
Loading...
