42 Raymarine Satellite TV Systems
4. Click the drop-down arrow at the right of the longitude box and select
W or E according to your longitude.
5. Click on the latitude box and enter your latitude in degrees and
minutes format.
6. Click the drop-down arrow at the right of the latitude box and select N
or S according to your latitude.
7. Click ‘Set GPS’ to save this information and set the GPS.
8. Click ‘Restart’. The system leaves set up mode and the antenna will
start tracking.
Method 2 - Selecting the nearest city.
If your are unable to enter your exact position, you can enter the latitude
and longitude for the nearest city.
1. Click ‘Set Antenna GPS and Find Antenna Angle’ in the menu options.
The set GPS screen is displayed.
2. Click ‘Setup’. The GUI will now enter set up mode.
3. Click on the arrow at the right of the ‘City’ box. A drop-down menu of
city names according to your area of operation (US or Europe) appears.
4. Scroll down the list and select the city which is nearest to your current
position. The latitude and longitude information for the selected city is
displayed.
5. Click ‘Set GPS’ to save this information.
6. Click ‘Restart’. The system leaves set up mode and the antenna will
start tracking.
Editing the satellite information
This section of the GUI enables you to edit satellite information
To edit a satellite’s information:
1. Click ‘Set Satellite Information’ in the menu options. The set satellite
information screen is displayed.
2. Click ‘Setup’. The GUI will now enter set up mode.
3. Click on the arrow at the right of the Satellite box. A drop-down menu
of satellites appears.
4. Scroll down and select the satellite that you want to edit. The satellite
name, its latitude and longitude and method of verification will be
displayed.
You can now change and edit the data for the selected satellite using the
following command buttons:
• Register for Satellite A - registers the selected satellite as Sat A of
the satellite pair.
• Register for Satellite B - registers the selected satellite as Sat B of
the satellite pair.
5. Click ‘Restart’. The system leaves set up mode and the antenna will
start tracking.
D8018_1
To Next Page
Loading...
Need help?
General
