Chapter 2: Installation 15
• If the cable is cut, it must be replaced—it cannot be repaired. Cutting the
cable will also void the warranty.
WARNING:
Removing the transducer cable from the rear of the DS400/500 while the
fishfinder is powered on can cause sparks. Only remove the transducer
cable after power has been removed from the DS400/500.
If the transducer cable is accidentally removed while the DS400/500 is
powered on, remove power from the fishfinder, replace the transducer
cable, and then restore power. As a safety feature, the DS400/500 only
recognizes that the transducer is connected at power-up.
bereitgestellt von Busse-Yachtshop.de
To Next Page
Loading...
