18 DS400 and DS500 Digital Fishfinders
Figure 2-7: Mounting Location on Single Drive Boat
Installation
Assembling
1. Insert the transducer’s pivot posts into the recesses on the sides of the
bracket (see Figure 2-8 ).
2. Press the two nuts into the slots in the back of the bracket.
3. Aligned the holes in the transducer, bracket, and nuts. Insert the two
machine screws capturing the nuts. Tighten the machine screws until the
transducer will stay in the “up” (released) position unaided.
Figure 2-8: Assembling the Transducer
75 mm (3")
minimum beyond
swing radius
D6764-1
pivot post (2)
recess (2)
bracket
nuts
machine
screws (2)
slot (2)
D6765-1
bereitgestellt von Busse-Yachtshop.de
To Next Page
Loading...
