Chapter 2: Installation 5
Chapter 2: Installation
2.1 Introduction
This chapter provides installation instructions for your DS600X.
Note: If you wish to practice using the unit before installation, connect the
power cable and use the simulator mode as described in Chapter 3. For pow-
er, connect a 12VDC power supply, attaching the red wire to positive and the
black wire to negative. See Section 3.3 for details.
2.2 Unpacking and Inspecting the Components
Unpack your system carefully, to prevent damage to the equipment. Save the
carton and packing, in case you need to return a unit for service.
Check that you have all the correct system components. These depend on
your system package, as follows:
:
The following accessories are available for your A Series Fishfinder:
Table 2-1: Supplied Parts
Item Part No.
One of the following units:
DS600X Digital Fishfinder without Transducer, US version
DS600X Digital Fishfinder without Transducer, CE version
E63065
E63066
Sun Cover E32050
Mounting Bracket E35005
Mounting Bracket Knobs W145
Power/NMEA cable R69074
Handbook, DS600X 81235
Mounting hardware N/A
Table 2-2: Optional Accessories
Item Part No.
Flush Mount Kit E32051
To Next Page
Loading...
