Chapter 4: Operating the Radio 37
4.13 Using the Scan Modes
The RAY101 is equipped with three types of scan options: All Scan, Saved
(Memory) Scan and Priority Scan. If there are no channels in memory, the default
is All Scan.
This function automatically searches for transmissions on the channel set being
scanned. If a TX signal is received, the scan stops on the receiving channel as long
as it is present and the SCAN indicator flashes. If the signal is lost for five seconds,
the radio resumes scanning.
During the Scan Modes:
• Press the Channel UP/DOWN key to change the scan direction.
UP increments the channel while DOWN decrements it.
• Press and release
SCAN/SAVE to terminate the SCAN mode.
•
DW/TRI and WX/BAND keys do not function and sound an error beep if
pressed.
All Scan
Press and release the SCAN/SAVE key when no channels are stored in memory to
activate the All Scan function.
The SCAN indicator appears on the LCD during All Scan.
To Next Page
Loading...
