50 S1 Wheel and Tiller Pilots Commissioning Guide
If y ou set
AUTOADAPT
to
nth
or
Sth
, you then n eed to enter your cu rrent
latitud e in the next screen (
LATITUDE
). If you have a GPS connected, the
SmartPil ot will take latitu de information from th e GPS .
Latitude
The SmartPilot only displays this screen if you have set
AUTOADAPT
to
nth
or
Sth
. Use the
1,+1, 10
and
+10
key s to set the value to your bo at’s curr ent
latitud e, to the nearest degree.
If vali d latitude data is available via SeaT alk or NMEA, the SmartPilot will use this
data inst ead of the calibration value.
System reset
WARNING: Losing settings at system reset
Do NOT u se this feature unless advised to do so by a Raymarine
dealer. If you complete a r eset you will lose ALL SmartPilot
calibr ation settin gs. Y ou will then need to repeat the SmartPilot
commissioning process.
Selecting Sy stem reset will reset all of the calibration values:
• all of the setting s in User Calibration, Seatrial Cal ibration and Dealer Calibra
tion will retu rn to the factory default v alues
• the settings in Display Calibration will not change, as these are stored in each
individ ual controller
T o reset the system:
1. Select the System reset (
RESET
) screen in Dealer Cali bration.
2. Press the
+1
key, then press
AUTO
.
3. The screen will then show an
ARE YOU SURE
message:
• press t he
+1
key ag ain to select ‘
YES
’ and reset the SmartPilot
• alternatively, press the
AUTO
key to cancel
4. Y ou will then see the
CAL LOCK
screen:
• press
standby
for 2 second s to save the new default settings, then turn
the SmartPi lot computer power off and back on
Scre en Text Range
LATITUDE 0°
to
80°
in 1° steps
81282_1.book Page 50 Monday, October 2, 2006 1:58 PM
To Next Page
Loading...
