Raypak 2350 Series User Manual

INSTALLATION & OPERATING
INSTRUCTIONS
Catalog No. 6000.553C Effective: 06-28-13 Replaces: 11-01-11 P/N 241429 Rev. 4
92-103778-02-05
FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and
liquids or other combustible materials in the vicinity of this or any other appliance. To
do so may result in an explosion or fire.
Heat Pump
Pool & Spa
Heater
USC
L
I
S
T
E
D
R
NOTE: The instructions in this manual are for the use of qualified individuals specially trained and experienced
in the installation and maintenance of this type of equipment and related system components. Installation and
service personnel are required by some states to be licensed. Persons not qualified shall not attempt to install,
service, or maintain this equipment.
This manual should be maintained in legible condition and kept adjacent to the heat pump pool heater or in a
safe place for future use.
Model Series
2350, 3350,
4350, 4350PD

Raypak 2350 Series Specifications

General

Brand	Raypak
Model	2350 Series
Category	Heat Pump
Language	English

Summary

Water Chemistry

General Safety Warnings

Introduction and Installation Overview

Installation Considerations

Crucial guidelines for proper unit placement, base requirements, and clearances.

Electrical Connections

Water Connections

Controls and Operation

Controls Operating Instructions

Step-by-step guide for selecting modes, setting temperatures, and unit modes.

System Start-Up and Shutdown

System Drain-Down

Procedures to protect the water circuit from freezing in cold weather conditions.

Continuous Pump Operation

Discusses using continuous pump operation to prevent freeze damage, noting cost implications.

Maintenance and Troubleshooting

Air Coil Cleaning

Instructions for cleaning the evaporator coil to ensure efficient operation and prevent damage.

Cabinet Care

Optional guidance on cleaning the unit's exterior cabinet for aesthetic purposes.

Condensation Drain Holes

Guidance on checking and clearing drain holes for normal condensation removal.

Service Call Verification

Power Supply & Water Flow Checks

Verifying electrical supply, water flow, and time clock settings before contacting service.

Time Clock Adjustment

Procedures for adjusting the time clock to ensure proper unit operation.

Remote Control Installation

Wiring Connections

Details the specific wiring required for remote control system integration.

Heater Settings

Plumbing Diagrams

Wiring Diagram - 208V/230V Single-Phase