To Next PageTo Next Page
Need help?Do you have a question about the Raypak PR206AMNC and is the answer not in the manual?
General| Model | PR206AMNC |
|---|---|
| Category | Heater |
| Heating Capacity | 206, 000 BTU/hr |
| Fuel Type | Natural Gas |
| Heat Exchanger Material | Copper |
| Ignition Type | Electronic |
| Thermal Efficiency | 82% |
| Max Working Pressure | 50 PSI |
| Voltage | 120V |
| Input BTU | 206, 000 BTU/hr |
| Type | Gas |
Defines hazard symbols (DANGER, WARNING, CAUTION, NOTE) and their implications.
Requirements for compliance with national and local installation codes.
Minimum clearances from combustible surfaces for installations.
Design certification for outdoor use and placement warnings.
Guidelines for vent pipe sizing, materials, and installation for safe exhaust.
Procedure for connecting the gas supply, including sediment trap.
Required upstream pressure for natural and propane gas supply.
Table for determining appropriate gas pipe size based on length and BTU input.
Requirements and procedure for installing a pressure relief valve.
Diagrams illustrating recommended pool heater water connections.
How to adjust temperature setpoints using the thermostat and knob stop ring.
Using the touchpad to select modes and adjust setpoint temperatures.
Accessing diagnostic information like flame strength, supply voltage, and run times.
Interpreting status messages for normal operation and active fault conditions.
Function and location of the water pressure switch for safety.
Purpose of the thermal cutoff device to prevent flame roll-out.
Detailed steps for lighting the pilot and operating millivolt heaters.
Instructions for lighting and operating digital ignition heaters.
Steps for starting and operating electronic ignition heaters.
Guidelines for operating the heater in freezing temperatures and avoiding freeze-ups.
Procedure for shutting down and winterizing the heater in freezing climates.
