RaySafe Solo - CT Setup Options

Dose unit Change the default units and/or use this feature to recalculate a value to a dierent
unit. (Dose: Gy, Gycm, R or Rcm, Temperature: °F or °C, Pressure: kPa or mmHg)
Backlight Display lighting option. (o, 2, 5, 10 s, on)
Auto Power O Never, or after 5, 20, 60 minutes of inactivity.
Info Displays the serial number (S/N) and firmware version of the connected detector
and the RaySafe Solo base unit and the calibration date for the sensor. There is
also a possibility to reset the instrument settings to factory defaults.
Temperature and pressure values are shown only in the RaySafe Xi View, not on the RaySafe Solo base unit
display.
18
RaySafe Solo User Manual – CT Measurement