Raytech USA, Inc. All rights reserved Ver. 1.13 6
FRONT PANEL DESCRIPTION: 5 – 0
Power Input Ext. Ground Terminal
100 to 240 vac For Opt. RS-232 Interface This terminal is spring loaded and threaded. Use the
50/60 Hz or Opt. DC Car Adapter the supplied ground wire to snap the spade between the
green and yellow part of the terminal. You may also use
a 4mm banana plug with this connector.
Panel mount printer (TR-1P only)
This panel mount printer allows the user to print out stored results or current results.
The single button on the printer is for Form-Feed.
To tear paper, pull paper towards the front of the instrument against the serrated cutting edge.
Rotary Knob
This is a multi-actuation rotary knob which is the main control and input.
This rotary knob allows the user to: Select the proper test voltage, input transformer data, store a test, adjust
contrast, view Archive data (previous Test Reports saved into memory), print a test.
Test lead connection
This is a keyed panel mount connector. Please make sure the
test leads are connected properly before making any tests.
To Next Page
Loading...