TM 03-006-UG
Copyright © 2004 Raytheon Company ALL RIGHTS RESERVED
Revision - 25
displayed for 5 seconds on the telephone LCD display. If there is no prior activity at the telephone, this
information is automatically displayed.
4.2.4 Answering an Incoming Call
When an incoming call arrives at the IST-2, the telephone begins to ring (provided the ringer is turned on)
and the user answers the call as follows:
a. Lift handset.
b. Perform one of the following:
• If the telephone has a home key defined and that is the ringing line, it answers automatically
when the user goes off-hook
• Locate and press telephone line button with flashing green LED.
c. When call is complete, either hang up handset, or press RELEASE key on telephone.
4.2.5 Answering a Pickup Group Call
If the telephone is in a call group (must be defined in the switch database), the Call Pickup feature is used to
answer any telephone in the group that is ringing. To use call pickup, an idle line must be selected.
NOTES
• Call pickup cannot be activated if the user called another party that has placed the user on hold.
• Pressing *3 will not automatically place the present call on consultation hold if auto hold is not
defined in the database. Place the call on hold prior to performing this feature.
a. When an unattended telephone in the pickup group is ringing, lift handset and listen for dial tone.
If home key is not enabled, press idle line button for dial tone.
b. Press *3 on the telephone dial-pad to answer unattended telephone.
c. When call is complete, either hang up handset or press RELEASE key on telephone.
4.2.6 Using Extension Pickup
Extension pickup allows another party that shares an SDN to:
• Enter into a point-to-point call and transition it into a progressive conference.
• Enter a progressive or preset conference.
To Next Page
Loading...