TM 03-006-UG
Copyright © 2004 Raytheon Company ALL RIGHTS RESERVED
Revision - 31
4.2.15 Using the Paging System
Using the Paging System:
a. Identify and press an idle line button. Listen for dial tone.
b. Press *9 key, listen for dial tone, enter paging zone number (0-9), and listen for connection, then make
announcement.
4.2.16 Night Answer for Trunk Circuits
To answer trunk calls during night service:
a. Identify and press an idle line button. Listen for dial tone.
b. Enter #9, listen for confirmation tone, then answer calls as received.
4.2.17 Conferencing
4.2.17.1 Creating Progressive Conference Using a Single Line Button
a. Lift handset and listen for dial tone.
If home key is not enabled, press idle button for dial tone.
b. Press a precedence key, if appropriate.
c. Dial telephone number and listen for ringback tone.
d. When called party answers, press PTT on handset and announce conference call.
e. Press RECALL DIAL key and listen for dial tone.
f. Dial telephone number of second party to be placed into conference call and listen for ringback.
NOTE
When using RECALL DIAL, the number must be manually dialed using the
telephone keypad. The call may be dropped if another line button is pressed.
g. When third party answers, press PTT on handset and announce the conference call.
h. Press CONF key.
Conference members receive entry tone and then begin conference.
i. Repeat steps e through h until all progressive conference members are added.
To Next Page