13
First of all, check all your Rayvolt
components as break and wheel status.
Start your battery using the key. The
display will show the battery level as
high, medium or low. Pull the throttle to
give an extra push to start. ATTENTION!
This will give you extra acceleration;
always have enough space.
Ride your bike as normal. The IPAS will
automatically start assisting when you
pedal. The IPAS is in level 3 by default.
Go to chapter … on EIVA user’s manual
to change the settings of the IPAS.
Feel the ride on your bike and check
the breaking response. Stop the ride
immediately if some of the components
do not work properly.
To stop riding, simply stop your bike and
remove the key to switch off the battery.
Riding your Rayvolt Bike
General Operation
To Next Page
Loading...
