Owner manual
In the event all is well connected and the problem is
not solved, it is needed to unplug the DC-Converter.
Disconnect it and test if the bike works now.
4. Brake sensors issue:
If it still has the same behaviour, disconnect the brake
sensors from the tank case. These are the two red plugs
on the tank wire.
5. Controller issue:
In the case it doesn’t solve the problem, open the
controller case and check if it has the red led on. To open
the controller case it is needed to remove the three
screws under the frame, just below the battery case.
Contact your nearest distributor or shop and explain the
process done and if the red led was on the controller, they
will give you further instructions.
Scenario 3:
Three lights on the throttle are on, there isn’t
assistance from pedal nor throttle.
If there is bluetooth connection.
To Next Page
Loading...
