EasyManua.ls Logo

Razor BGC2243M - User Manual

Razor BGC2243M
16 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Outdoor LP Gas Griddle
Model No. GGC1643MModel No. GGC1643M
（（Manufacture CodeManufacture Code：：BGC2243MBGC2243M））
OWNER’S OWNER’S MANUALMANUAL
Table of Contents
Important Safeguards ...........................................................Page 2
Expanded View & Hardware .......................................................... 4
Assembly Instructions............................................................... 5
Transporting & Storage Instructions .................................................... 8
Installing LP Gas Tank.............................................................. 11
Operating Instructions.............................................................. 11
Cleaning and Care ................................................................ 12
Product Registration ............................................................... 13
Replacement Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Limited Warranty ................................................................. 14
Troubleshooting .................................................................. 15
The use and installation must conform with local codes or, in the absence of local codes, with either the
National Fuel Gas Code, ANSI Z223.1/NFPA 54, Natural Gas and Propane Installation Code, CSA B149.1,
or Propane Storage and Handling Code, B149.2, or the Standard for Recreational Vehicles, ANSI A 119.2/
NFPA 1192, and CSA Z240 RV Series, Recreational Vehicle Code, as applicable.
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP
FOR FUTURE REFERENCE.
If you are assembling this unit for someone else, give this manual to them to read and save for future
reference.
Made from 75% Bagasse
(environmentally friendly sugar
cane pulp by-product)
WARNING
FOR YOUR SAFETY:
For Outdoor Use Only
(outside any enclosure)
WARNING
FOR YOUR SAFETY:
1. Improper installation, adjustment,
alteration, service or maintenance can
cause injury or property damage.
2. Read the installation, operation, and
maintenance instructions thoroughly
before installing or servicing this
equipment.
3. Failure to follow these instructions could
result in fire or explosion, which could
cause property damage, personal injury, or
death.
4. This instruction manual contains important
information necessary for the proper
assembly and safe use of the appliance.
5. Read and follow all warnings and
instructions before assembling and using
the appliance.
6. Follow all warnings and instructions when
using the appliance.
7. Keep this manual for future reference.
DANGER
If you smell gas -
1. Shut off gas to appliance.
2. Extinguish any open flame.
3. Open lid.
4. If odor continues, keep away from the
appliance and immediately call your gas
supplier or your fire department.
WARNING
FOR YOUR SAFETY:
1. Do NOT store or use gasoline or other
flammable liquids or vapors in the vicinity
of this or any other appliance.
2. An LP cylinder not connected for use shall
NOT be stored in the vicinity of this or any
other appliance.
DANGER
Never operate this appliance unattended.
Manufactured in China for: RevoAce Inc. Limited
Hong Kong, China • 1.800.694.0013 • service@revoace.com
8:00 am to 4:00 pm central time, Monday to Friday.
© RevoAce Inc. Limited
Razor
®
is a registered trademark of Mr. Bar-B-Q Products LLC. Used with permission.
GriddleOn is a trademark of Mr. Bar-B-Q Products LLC. Used with permission.
Make it Sizzle
TM
is a trademark of Mr. Bar-B-Q Products LLC. Used with permission. GGC1643M-E-OM-F103
IMPORTANT
After each use, always season your griddle per “Seasoning
Griddle” section.
PATENT NO. D857,439 S
D909,131 S
WARNING
FOR YOUR SAFETY:
DO NOT LEAVE THIS APPLIANCE UNATTENDED
WHILE IN USE.
razorgriddle.com
@razorgriddle
@razorgriddle
¸ WARNING: This product can expose you to chemicals including carbon monoxide,
soot, lead and lead components,which are known to the State of California to cause
cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.

Table of Contents

Questions and Answers

  • E
    elizabethrobertsonAug 16, 2025
    What to do if the Razor BGC2243M Griddle burner won't light using the igniter?
    • J
      Jennifer LewisAug 16, 2025
      If the burner of your Razor Griddle won't light using the igniter, several factors could be at play. First, ensure the LP gas tank valve is open and the regulator is securely attached. If the tank is low or empty, replace or refill it. Cooking residue on the wires or electrode can also be the culprit, so try cleaning them with rubbing alcohol. If the electrode and burners are wet, wipe them dry. For cracked/broken electrodes, loose/disconnected wires, shorting wires, or a bad igniter, replacement parts may be needed, so contact Customer Care.
  • Q
    qcolemanAug 19, 2025
    Why is the flame yellow or orange on my Razor BGC2243M?
    • J
      Joseph SuttonAug 20, 2025
      If the flame on your Razor Griddle is yellow or orange, it could be due to a few reasons. If it's a new burner, residual manufacturing oils might be present; burn the griddle for 15 minutes on high with the lid closed. Spider webs or insect nests in the venturi can also cause this issue, so clean the venturi. Additionally, food residue or grease on the burners can affect the flame, so ensure they are clean. Finally, check the alignment of the valve to the burner/venturi tube to ensure they are properly engaged.
  • J
    John WalkerAug 22, 2025
    Why is there a sudden drop in gas flow or reduced flame height on my Razor Griddle?
    • J
      John YoungAug 22, 2025
      A sudden drop in gas flow or reduced flame height in your Razor Griddle can occur if the LP gas tank is out of gas; in this case, exchange, refill, or replace the LP gas tank. Alternatively, the overfilling prevention device may have been activated. To address this: turn the control knobs to “ OFF”, wait 30 seconds, and light the griddle. If flames are still too low, reset the overfilling prevention device by turning the control knob(s) “ OFF”, turning the LP gas tank valve to “CLOSED”, disconnecting the regulator, turning control knobs to and (HIGH), waiting 1 minute, turning control knobs to “ OFF”, reconnecting the regulator and leak checking connections, and lighting the griddle.
  • C
    Cheyenne FloresAug 26, 2025
    What to do if the Razor BGC2243M burner will not light with a match?
    • M
      Mallory MartinAug 26, 2025
      If the burner of your Razor Griddle won't light with a match, several issues could be the cause. First, check if the LP gas tank is empty and exchange, refill, or replace it if needed. If the tank isn't empty, there might be no gas flow, refer to “Sudden drop in gas flow or reduced flame height”. Ensure the coupling nut and regulator are fully connected by tightening the coupling nut by hand until a solid stop. Also, check for any obstruction of gas flow by clearing the burner/venturi tube and inspecting for bent or kinked hoses. Make sure the burner is properly engaged with the valve, and clean the burner/venturi tube to remove any spider webs or insect nests. Finally, clean any clogged or blocked burner ports.
  • B
    bradleypaulAug 28, 2025
    How to prevent flare-ups on my Razor BGC2243M Griddle?
    • C
      Crystal LopezAug 28, 2025
      Flare-ups on your Razor Griddle can be caused by grease buildup, so remove and clean all griddle parts. Excess fat in the meat can also contribute; trim fat from meat before cooking. High cooking temperatures may also be the cause, so adjust to a lower cooking temperature.
  • R
    Roberto JacobsAug 31, 2025
    Why does the flame go out on my Razor Griddle?
    • J
      Justin WilliamsAug 31, 2025
      If the flame on your Razor Griddle goes out, it could be due to high or gusting winds; avoid using the griddle in such conditions. It could also be due to low LP gas, so exchange, refill, or replace the LP gas tank. Alternatively, the overfilling prevention device may have been activated; refer to “Sudden drop in gas flow or reduced flame height”.
  • E
    edwardskimSep 3, 2025
    Why is there an irregular flame pattern on my Razor BGC2243M?
    • E
      Eileen GrahamSep 3, 2025
      An irregular flame pattern on your Razor Griddle, where the flame doesn't run the full length of the burner, is typically due to clogged or blocked burner ports. Cleaning the burner ports should resolve this issue.
  • M
    Mr. Devon Harrison PhDSep 6, 2025
    What to do about a persistent grease fire on my Razor BGC2243M?
    • B
      Brittany LawrenceSep 6, 2025
      A persistent grease fire on your Razor Griddle is likely due to grease trapped by food buildup around the burner system. To address this, turn the control knobs to “ OFF”, turn the LP gas tank valve to “CLOSED”, leave the lid in closed position and let the fire burn out. After the griddle cools, remove and clean all parts.
  • D
    David BurtonSep 9, 2025
    What causes flashback (fire in burner tube(s)) in my Razor BGC2243M Griddle?
    • S
      Sergio LopezSep 9, 2025
      Flashback, or fire in the burner tubes of your Razor Griddle, indicates that the burners and/or burner/venturi tube are blocked. Cleaning these parts should resolve the issue.
  • C
    Catherine HillSep 12, 2025
    Why has my Razor BGC2243M started to rust?
    • E
      emurraySep 12, 2025
      With use the griddle surface will rust, this is normal. Follow the “Refurbish the Griddle Surface” instructions in the “Seasoning Griddle” section to season your griddle surface.

Razor BGC2243M Specifications

General IconGeneral
BrandRazor
ModelBGC2243M
CategoryGriddle
LanguageEnglish

Related product manuals