EasyManua.ls Logo

Razor GGC2241M-A - User Manual

Razor GGC2241M-A
16 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Outdoor LP Gas Griddle
Model No. GGC2241M-AModel No. GGC2241M-A
(Manufacture Code(Manufacture Code：：BGC2241M)BGC2241M)
OWNER’S OWNER’S MANUALMANUAL
Table of Contents
Important Safeguards ...........................................................Page 2
Expanded View & Hardware .......................................................... 4
Assembly Instructions............................................................... 5
Transporting & Storage Instructions .................................................... 8
Optional Part Instructions ........................................................... 11
Installing LP Gas Tank.............................................................. 13
Operating Instructions.............................................................. 13
Cleaning and Care ................................................................ 14
Product Registration ............................................................... 15
Replacement Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
Limited Warranty ................................................................. 15
Troubleshooting .................................................................. 16
The use and installation must conform with local codes or, in the absence of local codes, with either the
National Fuel Gas Code, ANSI Z223.1/NFPA 54, Natural Gas and Propane Installation Code, CSA B149.1,
or Propane Storage and Handling Code, B149.2, or the Standard for Recreational Vehicles, ANSI A 119.2/
NFPA 1192, and CSA Z240 RV Series, Recreational Vehicle Code, as applicable.
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP
FOR FUTURE REFERENCE.
If you are assembling this unit for someone else, give this manual to them to read and save for future
reference.
Made from 75% Bagasse
(environmentally friendly sugar
cane pulp by-product)
WARNING
FOR YOUR SAFETY:
For Outdoor Use Only!
(outside any enclosure)
WARNING
FOR YOUR SAFETY:
1. Improper installation, adjustment,
alteration, service or maintenance can
cause injury or property damage.
2. Read the installation, operation, and
maintenance instructions thoroughly
before installing or servicing this
equipment.
3. Failure to follow these instructions could
result in fire or explosion, which could
cause property damage, personal injury, or
death.
4. This instruction manual contains important
information necessary for the proper
assembly and safe use of the appliance.
5. Read and follow all warnings and
instructions before assembling and using
the appliance.
6. Follow all warnings and instructions when
using the appliance.
7. Keep this manual for future reference.
DANGER
If you smell gas -
1. Shut off gas to appliance.
2. Extinguish any open flame.
3. Open side shelves.
4. If odor continues, keep away from the
appliance and immediately call your gas
supplier or your fire department.
WARNING
FOR YOUR SAFETY:
1. Do NOT store or use gasoline or other
flammable liquids or vapors in the vicinity
of this or any other appliance.
2. An LP cylinder not connected for use shall
NOT be stored in the vicinity of this or any
other appliance.
DANGER
Never operate this appliance unattended.
Manufactured in China for: RevoAce Inc. Limited
Hong Kong, China • 1.800.694.0013 • service@revoace.com
8:00 am to 4:00 pm central time, Monday to Friday.
© RevoAce Inc. Limited
Razor
®
is a registered trademark of Mr. Bar-B-Q Products LLC. Used with permission.
GriddleOn is a trademark of Mr. Bar-B-Q Products LLC. Used with permission.
Make it Sizzle
TM
is a trademark of Mr. Bar-B-Q Products LLC. Used with permission. GGC2241M-A-RA-E-OM-F102
IMPORTANT
After each use, always season your griddle per “Seasoning
Griddle” section.
WARNING
FOR YOUR SAFETY:
DO NOT LEAVE THIS APPLIANCE UNATTENDED
WHILE IN USE.
razorgriddle.com
@razorgriddle
@razorgriddle
¸ WARNING: This product can expose you to chemicals including carbon
monoxide, soot, lead and lead components
, which are known to the State
of California to cause cancer and birth defects or other reproductive harm.
For more information go to www.P65Warnings.ca.gov.
PATENT NO. D909,131S
AND OTHER PATENTS PENDING

Table of Contents

Questions and Answers

  • M
    mcintyrekatherineAug 16, 2025
    Why won't the burner light using the igniter on my Razor Griddle?
    • R
      ryan22Aug 16, 2025
      If the burner on your Razor Griddle won't light using the igniter, there are several possible causes: * The LP gas tank valve might be closed. Ensure the regulator is securely attached to the LP gas tank and then turn the LP gas tank valve to the “OPEN” position. * The LP gas tank could be low or empty. Exchange, refill, or replace the LP gas tank. * There might be LP gas present. Turn the LP gas tank valve to “CLOSED,” wait 5 minutes for the gas to clear, and then follow the “Checking for Leaks” section. * The wires or electrode could be covered with cooking residue. Clean the wire and/or electrode with rubbing alcohol. * The electrode and burners might be wet. Wipe them dry with a cloth.
  • Y
    Yvonne MccarthyAug 19, 2025
    Why won't the burner light with a match on my Razor GGC2241M-A Griddle?
    • S
      stokesandreaSep 12, 2025
      If the burner on your Razor Griddle won't light with a match, here's what might be happening: * There may be no gas flow. Check if the LP gas tank is empty. If it is, exchange, refill, or replace the LP gas tank. If the LP gas tank is not empty, refer to “Sudden drop in gas flow or reduced flame height”. * The LP gas tank might be low or empty. Exchange, refill, or replace the LP gas tank. * There might be LP gas present. Turn the LP gas tank valve to “CLOSED,” wait 5 minutes for the gas to clear, and then follow the “Checking for Leaks” section. * The coupling nut and regulator might not be fully connected. Turn the coupling nut about one-half to three-quarters additional turn until solid stop. Tighten by hand only - do NOT use tools.
  • H
    hunterreginaldAug 22, 2025
    What to do if there is a sudden drop in gas flow on my Razor GGC2241M-A Griddle?
    • C
      Carol RodgersAug 22, 2025
      If you experience a sudden drop in gas flow or reduced flame height on your Razor Griddle, it could be due to: * Being out of gas. Exchange, refill, or replace the LP gas tank. * The overfilling prevention device may have been activated. To reset it: 1. Turn control knobs to “ OFF”. 2. Wait 30 seconds and light griddle. 3. If flames are still too low, reset the overfilling prevention device: * Turn control knob(s) “ OFF”. * Turn LP gas tank valve to “CLOSED”. * Disconnect regulator. * Turn control knobs to (HIGH). * Wait 1 minute. * Turn control knobs to “ OFF”. * Reconnect regulator and leak check connections, being careful not to fully open valve. * Light griddle per “Lighting” section.
  • D
    durhamandrewAug 25, 2025
    How to prevent flare-ups on my Razor GGC2241M-A?
    • B
      brenda30Aug 26, 2025
      A flare-up on your Razor Griddle may occur due to: * Grease buildup. Remove and clean all griddle parts. * Excess fat in meat. Trim fat from meat before cooking. * Excessive cooking temperature. Adjust to a lower cooking temperature.
  • H
    Heather EstesAug 28, 2025
    Why is the flame yellow or orange on my Razor GGC2241M-A Griddle?
    • M
      Matthew OrtizAug 28, 2025
      If the flame on your Razor Griddle is yellow or orange, it could be caused by: * A new burner having residual manufacturing oils. Burn the griddle for 15 minutes on (HIGH). * Spider webs or insect nest in venturi. Clean the venturi. * Food residue, grease, etc. on burners. Clean the burner. * Poor alignment of valve to burner/venturi tube. Ensure burner/venturi tube is properly engaged with valve.
  • J
    joanne49Aug 31, 2025
    What to do if the flame goes out on my Razor Griddle?
    • V
      vrobinsonAug 31, 2025
      If the flame goes out on your Razor Griddle, it might be because of: * High or gusting winds. Do not use the griddle in high winds. * Being low on LP Gas. Exchange, refill, or replace the LP gas tank.
  • T
    Tyler CrawfordSep 3, 2025
    Why is the flame pattern irregular on my Razor Griddle?
    • S
      Stanley JenningsSep 3, 2025
      If you observe an irregular flame pattern where the flame doesn't run the full length of the burner on your Razor Griddle, it's likely that the burner ports are clogged or blocked. Cleaning the burner ports should resolve this issue.
  • A
    andrea44Sep 6, 2025
    What causes a persistent grease fire on my Razor GGC2241M-A?
    • B
      Betty DiazSep 6, 2025
      A persistent grease fire on your Razor Griddle is likely due to grease trapped by food buildup around the burner system. To resolve this: 1. Turn control knobs to “ OFF”. 2. Turn LP gas tank valve to “CLOSED”. 3. After the griddle cools, remove and clean all parts.
  • Q
    qperezSep 9, 2025
    What causes flashback on my Razor GGC2241M-A Griddle?
    • D
      Derek FrankSep 9, 2025
      Flashback (fire in burner tube(s)) on your Razor Griddle can occur if the burner and/or burner/venturi tube are blocked. Clean the burners and/or burner/venturi tube to resolve this issue.
  • J
    Julie NguyenSep 12, 2025
    Why is my Razor GGC2241M-A surface rusting?
    • M
      Michael HaydenSep 12, 2025
      With use the griddle surface will rust, this is normal. Follow the “Refurbish the Griddle Surface” instructions in the “Seasoning Griddle” section.

Razor GGC2241M-A Specifications

General IconGeneral
BrandRazor
ModelGGC2241M-A
CategoryGriddle
LanguageEnglish

Related product manuals