4
ASSEMBLY AND SET-UP
1
Remove the plastic packing material from the caster
wheel. Discard the plastic packing material.
2 Put the wheel screw into the frame tube and using
a 5 mm Allen wrench, tighten the bolt under the rear
wheel caster.
Attaching the Rear Caster Wheels
Required Tool: 5 mm Allen Wrench (included)
WARNING: Failure to
properly tighten the bolts that affix
the wheels can cause you to lose
control and crash.
Note: Practice riding only in wide
open areas clear from curbs,
parking blocks and other obstacles.
Impacting the wheels against
any hard surface can damage the
wheels. Wheels are not covered
under your limited warranty.
To Next Page
Loading...
