Razor Dirt Rocket MX350 - Chain and Rear Tire Replacement - Dirt Rocket MX350

6
REPAIR AND MAINTENANCE
❑
Chain and Rear Tire Replacement - Dirt Rocket MX350
Tools required:
10mm wrench, two (2) 8mm wrenches, and two (2) 17mm wrenches.
2
With a 10mm wrench, loosen
the brake cable anchor and
disconnect the cable.
3
With two 8mm wrenches,
loosen brake housing anchor and
disconnect. Keep the spacer and
washers together.
4
With two 17mm wrenches,
loosen the axle. Push the wheel
forward in the slots to loosen the
chain.
Note:
Your hands will get greasy
doing this.
5
Pull the wheel out. Note the
arrangement of the hardware
sequence.
6
Install the new chain or wheel
by slipping the chain around the
axle. Slide the axle into the slots on
the frame. Slide the wheel forward
and maneuver the chain onto the
rear sprocket, front sprocket and
chain tensioner.
7
To hook up the brake housing
anchor, align the cable guide
adjuster and install the spacer and
bolt. Do not tighten until fi nal step.
8
Install the brake spring and
thread the cable wire into the cable
anchor. Thread the cable to its
original position and tighten
securely.
9
Tighten the brake housing
anchor securely. Re-attach the
chain guard. Test ride and check.
Readjust as needed.
1
Loosen screw and remove chain
guard.