Razor E300 HD

BEFORE YOU BEGIN
3
Remove contents from box. Remove the separators that protect the components from damage during shipping.
Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during
shipping. Because the scooter was 95 percent assembled and packed at the factory, there should not be any
problems, even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult.
Allow up to 10 minutes for assembly, not including initial charge time.
Allow up to 12 hours for charge (see page 5 for charging information).
WARNING:
DO NOT USE NON-RAZOR
PRODUCTS WITH YOUR RAZOR
ELECTRIC SCOOTER. The scooter
has been built to certain Razor
design specifications. The original
equipment supplied at the time
of sale was selected on the basis
of its compatibility with the
frame, fork and all other parts.
Certain aftermarket products
may not be compatible and will
void the warranty.
Charger
(Note: Charger design may vary from
one shown)
Brake Lever
1.
3.
Handlebar Stem
Collar Clamp
Hub Motor
Limiter
Fork
ON/OFF Switch
Charger Port
Reset Button
Battery
Control
Module
Twist-Grip Throttle
Product ID Locations:
(See locations to the left)
1. Handlebar Stem
2. Underneath Battery Tray
3. Charger
4. UPC side of box (not shown)
Plastic Bag Contents:
• Charger
• Tool
• Owner’s Manual
Required Tool
5 mm
Allen Wrench
Note: Electric scooter must be
moving at least 3 mph (5km/h)
while applying throttle to
engage motor.
2.