headline
6
ASSEMBLY AND SET-UP
6
A
C
B
D
Installing the Basket
The passenger seat must be removed before basket installation. Passenger seat and basket cannot be installed on
EcoSmart Cargo at the same time.
Required Tool: 5 mm Allen Wrench (included)
1 Pull strap on passenger seat. 2 Open storage compartment. 3 Using a Phillips screwdriver,
remove the six (6) screws that
secure the storage compartment
and the passenger seat to the
rear frame. Remove the storage
compartment and passenger seat
and store for future use. To reinstall
passenger seat, reverse steps 1-3.
Removing the Passenger Seat
Required Tool: Phillips Screwdriver (not included)
WARNING: The basket
should not be used to carry people
or pets.
1 Slide the basket hooks (A) under
the crossbar (B) located on the rear
frame.
2 Align the hole in the basket (C)
with the hole on the rear frame (D).
Insert the washer and bolt into the
hole in the basket and through the
bracket on the rear frame.
3 Using a 5 mm Allen wrench,
tighten the bolt until the basket is
securely attached to the rear frame.
Note: For basket removal, reverse
steps 1-3. After removal, store
basket for future use.
To Next Page
Loading...
