HEADLINE
8
REPAIR AND MAINTENANCE
8
Turn power switch “OFF” before conducting any maintenance procedures.
Adjusting the Brake
Required Tool: 10 mm Wrench (not included)
Replacing the Fuse
Required Tool: 4 mm Allen Wrench (not included)
1 To adjust the brake cable tension,
thread the brake lever adjuster in or
out 1/4 to 1/2 turn until the desired
brake adjustment is attained. Most
adjustments are complete at this
step. If brake still needs further
adjustment, proceed to step 2.
1 Using a 4 mm Allen wrench remove the four (4) screws on the deck and
remove the deck plate.
3 Close the fuse box and reattach
the deck plate by reversing
instructions in Step# 1.
2 Open the fuse cover to expose the fuse. Remove the damaged or burned
out fuse and replace with a new one of equal amperage.
Note: Amperage is located on top of fuse.
2 If the brake is too tight or too
loose, use a 10 mm wrench to loosen
the nut for additional adjustment on
the brake cable. Securely tighten the
nut when finished.
Amperage
number
WARNING: To prevent
shock, please follow the
instructions accordingly and do not
skip any steps.
WARNING: The brake is
capable of skidding the rear tire
and throwing an unsuspecting rider.
Practice in an open area free from
obstacles until you are familiar with
the brake function. Avoid skidding to
a stop as this can cause you to lose
control and/or damage the rear tire.
To Next Page
Loading...
