Razor jetts - Product Setup and Adjustment; Adjusting the Jetts Fit

A
B
B
A
4
SET-UP
Adjusting the Jetts
1
To make strap longer: Follow
direction of the arrows to adjust.
Pull the inner strap first (A), then
the outer strap (B).
4 Follow the direction of the
arrow to insert foot.
7 Pull tab down to secure the
strap. Align and press together
hook and pile sides of the strap.
Make sure it is completely secure.
2 To make strap shorter:
Follow direction of the arrows to
adjust. Pull the outer strap first (A),
then the inner strap (B).
5 Place foot in heel wheel
and push the frame from both
sides until it clicks into place
snuggly fitting width of shoe.
Note: Adjustment must be done
while wearing recommended
appropriate footwear.
8 Make certain tab is on outside
of shoe.
6 Follow direction of the arrow
to tighten strap. Shoes must be
snuggly attached to the heel
wheels before using.
3 Press the button and pull the
frame to its maximum width.
WARNING: Failure to properly adjust the Jetts may cause the user to lose control and fall.