6
ASSEMBLY AND SET-UP
Inflating the Tires
Tires are inflated when shipped, but they invariably may lose some pressure between the point of manufacturing and
your purchase. Always inflate the tires to the correct PSI before first time use.
Lower air pressure can result in a shorter ride time.
Periodically check both tires. Reinflate when needed.
Using a bicycle tire pump equipped
for a Schrader valve, inflate the tires
to the PSI indicated on the sidewall
of the tires.
WARNING:
Do not use the Pocket Mod Petite
for the first time until you have
inflated the tires to the correct
PSI. Failure to do so may damage
your Pocket Mod Petite and void
your warranty.
WARNING:
Do not overinflate, as this could
damage the tire or wheel.
Note: The pressure air supplies
found at gasoline stations are
designed to inflate high-volume
automobile tires. If you decide to
use such an air supply to inflate
your Pocket Mod Petite tires, first
make sure the pressure gauge
is working, then use very short
bursts to inflate to the correct PSI.
If you inadvertently overinflate
the tires, release the excess
pressure immediately.
To Next Page
Loading...
Need help?
General
