Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer
Service contact information is listed at the back of this manual.
8
USAGE
REPAIR AND MAINTENANCE
1 To adjust the tension, thread the
brake lever adjuster on the hand
brake in or out 1/4 to 1/2 turn until
the desired brake adjustment is
attained. Most adjustments are
complete at this step. If brake still
needs further adjustment, proceed
to step 2.
2 If brake is too tight or has too
much slack, use a 10 mm wrench
to loosen the nut for additional
adjustment on the brake cable on
the rear wheel. Securely tighten nut
when done.
Starting the Pocket
Mod Petite
Once seated, place both hands on the handlebars. Slowly
push forward with one foot and apply the throttle.
Note: Keep both feet on the base fairing when product is
in motion.
Stopping the Pocket
Mod Petite
Release the throttle and apply the brake.
Note: When coming to a complete stop, place both feet
on the ground to balance the product.
Note: As an additional safety
feature, the Pocket Mod Petite is
designed to cut power to the motor
when the hand brake is applied.
Testing the Brake
To use the brake, squeeze the brake lever to increase the pressure on the brake. The brake lever is fitted with a cable
adjuster to compensate for cable stretch and/or to fine-tune the lever movement to brake engagement. If brake is not
engaging properly, follow instructions for adjusting the brake.
Adjusting the Brake
Tool Required: 10 mm Wrench
Turn power switch “OFF” before beginning repair or maintenance:
• Read the instructions
• Remove charger plug
• Turn the power switch off
• Secure the product under repair
• Exercise caution around
exposed parts
• Contact Razor customer
service if unsure about any
repair or maintenance
WARNING: The brake is
capable of skidding the tire and
throwing an unsuspecting rider.
Practice in an open area, free from
obstacles, until you are familiar with
the brake function. Avoid skidding to
a stop as this can cause you to lose
control or damage the rear tire.
Note: The brake lever contains a
safety switch to cut power to the
motor when the brake is applied. In
an emergency, applying the brake
will always stop the product from
moving. Do not disable or replace
this lever with anything other than a
genuine Razor replacement part.
To Next Page
Loading...
Need help?
General
