Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information 
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer 
Service contact information is listed at the back of this manual.
2
BEFORE YOU  BEGIN
Remove contents from box. Remove the separators that protect the components from damage during shipping. 
Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during 
shipping. Because the scooter was 95 percent assembled and packed at the factory, there should not be any 
problems, even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY ASSEMBLY OR  
MAINTENANCE PROCEDURES.
 Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult.
Allow up to 10 minutes for assembly, not including initial charge time.  
Allow up to 12 hours for charge (see page 5 for charging information).
WARNING: 
DO NOT USE NON-RAZOR 
PRODUCTS WITH YOUR RAZOR 
ELECTRIC SCOOTER. The scooter 
has been built to certain Razor 
design specifications. The original 
equipment supplied at the time 
of sale was selected on the basis 
of its compatibility with the 
frame, fork and all other parts. 
Certain aftermarket products 
may not be compatible and will 
void the warranty.
Note: Electric scooter must be 
moving at least 3 mph (5km/h) 
while applying throttle to  
engage motor.
Product ID Locations: 
(See locations to the left)
1.  Handlebar Stem
2.  Underneath Battery Tray
3.  Charger
4.  UPC Side of Box (Not Shown)
Box Contents: 
• Electric Scooter
• Charger
• Tool(s)
• Owner’s Manual
Charger 
(Note: Charger design may vary from 
one shown)
Twist-Grip Throttle
Brake Lever
Collar Clamp
Limiter
1.
On/Off Switch
Charger Port
- Battery
- Control Module
Hub Motor
3.
2.
Seat (Power Core E100S only)
 Required Tools
5 mm Allen Wrench (Included)
Two (2) 4 mm Allen Wrenches
(Included - Power Core E100S only)