5
ASSEMBLY AND SET-UP
Using a bicycle tire pump equipped for a Schrader valve, inflate both tires to
the PSI indicated on the sidewall of the tire.
WARNING: Do not use|
the RSF350 for the first time until
you have inflated the tires to the
correct PSI. Failure to do so may
damage your motor bike and void
your warranty.
WARNING: Do not
overinflate, as this could damage
the tire or wheel.
Note: The pressurized air supplies
found at gasoline stations are
designed to inflate high-volume
automobile tires. If you decide to
use such an air supply to inflate
your tires, first make sure the
pressure gauge is working, then
use very short bursts to inflate to
the correct PSI. If you inadvertently
overinflate the tire, release the
excess pressure immediately.
Inflating the Tires
Tires are inflated when shipped, but they invariably lose some pressure between the point of manufacturing and your
purchase. Inflate the tires to the correct PSI before first time use.
Note: Lower air pressure can result in a shorter ride time.
Periodically check both tires. Reinflate when needed.
To Next Page
Loading...
