What to do if there is no sound from RBH Sound A-610?
If you're experiencing no sound from your RBH Sound speakers, the issue might stem from a disconnected speaker wire or an inactive speaker selector on your amplifier. Ensure the speaker wire is properly connected to both the speaker and the amplifier, paying attention to polarity. Also, verify that the correct speaker selector is activated on your amplifier.
Why is there no sound from one of my RBH Sound A-610 Speakers?
If you're getting no sound from one RBH Sound speaker, it could be due to the balance control on your receiver or preamp not being centered, or a speaker wire that isn't fully connected. Make sure the balance control is in the center position. Then, check all connections at both the amplifier and the speakers to ensure they are secure.
How to fix very little bass and/or imaging on RBH Sound A-610 Speakers?
If you notice very little bass or poor imaging from your RBH Sound speakers, the speakers might be wired out of phase. Check your entire system to ensure proper polarity and make any necessary adjustments.
Allows 10-15 hours of listening time to loosen speaker suspension for improved performance.
Highlights swing-out dog leg mounting, directional swivel tweeters, and polyswitch protection circuitry.
Instructions on painting speaker grilles and frames to maintain sound quality.
Guidance on aiming swivel tweeters for optimal imaging and diffuse sound fields.
Instructions for installing speakers when using a new construction bracket.
Steps for installing speakers using a cutout template and pilot hole.
Detailed steps for using the provided template to cut drywall for speaker installation.
Procedure for connecting speaker wire to the terminals, including gauge selection and polarity.
Steps to secure the speaker, tighten mounting screws, and install the grille.
Description of the rear enclosure (BB-S) for improving sound quality and isolation.
Use of blank plates to cover unused openings after bracket installation.
Benefits of New Construction Brackets for easier and faster installation.
General| Type | In-wall Speaker |
|---|---|
| Sensitivity | 90dB (2.83V @ 1 Meter) |
| Impedance | 8 Ohms |
| Crossover Frequency | 2.5kHz |
| Power Handling | 100 Watts |
| Grille | Paintable |
| Dimensions | 12.5" x 8.5" |
To Next Page
