Why is there no sound from my RBH Sound Speakers?
If there is no sound coming from your RBH Sound Speakers, the issue could be due to a disconnected speaker wire. Ensure the wire is properly connected to both the speaker and the amplifier, paying attention to the correct polarity. Alternatively, the speaker selector on your amplifier might not be activated. Make sure the appropriate speaker selector is turned on.
What to do if there is no sound from one RBH Sound Speaker?
If you're only getting sound from one RBH Sound Speaker, start by checking the balance control on your receiver or preamp. Make sure it's centered. Also, inspect all speaker wire connections at both the amplifier and the speakers to ensure they are completely connected.
How to fix very little bass and/or imaging on RBH Sound TK-8 Speakers?
If you're experiencing very little bass and/or poor imaging with your RBH Sound Speakers, it's possible that the speakers are wired out of phase. Check your entire system for correct polarity and adjust as needed.
Guide to connecting speaker wire, ensuring correct polarity and wire gauge selection.
Addresses situations where no sound is produced, citing wire connection and polarity issues.
Diagnoses issues with one speaker not producing sound, checking balance and connections.
Explains causes for poor bass or imaging, such as wiring out of phase or incorrect system setup.
General| Type | In-wall Speaker |
|---|---|
| Impedance | 8 Ohms |
| Sensitivity | 90 dB (2.83V @ 1 meter) |
| Tweeter | 1-inch silk dome |
| Crossover Frequencies | 2.5kHz |
| Driver Configuration | 2-way |
| Power Handling | 150 Watts |
| Driver Size | 8 inches |
| Woofers | 8-inch aluminum cone |
| Dimensions (H x W x D) | 10.5 x 3.5 inches |
| Woofer Size | 8 inches |
| Grille | Paintable |
| Frequency Response | 45Hz-20kHz ±3dB |
To Next Page
