39
5. To exit remote operation, hang up. The system will automatically
disconnect the call if the user does not enter a command within 10
seconds.
NOTE: Only the message being played can be erased in remote access mode.
Memory Full
When the answering system memory is full, the system answers after 10
rings. “Memory full” will be announced and waits for you to enter 3-digit
security code. If you don’t enter the security code within 7 seconds, the
phone hangs up.
You should erase some messages so the answering system may record new
messages.
NOTE: The unit also answers after the 10th ring if it is set to Answer Off. To
access the answering system, enter your 3-digit security code.
Changing the Battery
CAUTION: To reduce the risk of fire or personal injury, use only
the Thomson Inc. approved Nickel-metal Hydride (Ni-MH)
battery model 5-2734, which is compatible with this unit.
1. Make sure the telephone is OFF (not in Talk mode) before you replace
battery.
2. Remove the battery compartment door.
3. Disconnect the battery plug from the jack inside the battery
compartment and remove the battery pack from the handset.
4.
Insert the new battery pack and connect the cord to the jack inside the
battery compartment.
5.
Put the battery compartment door back on.
6. Place handset in the base or handset charge cradle to charge. Allow the
handset battery to properly charge (for 14 hours) prior to first use or
when you install a new battery pack. If you do not properly charge
the phone, battery performance will be compromised.
Battery Safety Precautions
• Do not burn, disassemble, mutilate, or puncture. Like other batteries of
this type, toxic materials could be released which can cause injury.
• To reduce the risk of fire or personal injury, use only the Nickel-metal
Hydride battery listed in the User’s Guide.
•
Keep batteries out of the reach of children.
• Remove batteries if storing over 30 days.
Other Information
To Next Page
Loading...
