31
Troubleshooting Checks
Trouble
No Power
Here’s What to Try
¥ Make sure all components are plugged in as instructed in
the Installation & Hookup Guide.
¥ Check circuit breaker for the wall outlet.
¥ If a disconnect switch was added to the system, but sure it is
in the ON position.
Remote locks up or doesnÕt work at all
¥ Remove batteries for 2 minutes then reinstall the batteries
and try remote again.
¥ Maybe batteries were installed incorrectly. Remove batteries
and reinstall correctly.
CD changer will not turn on with remote
¥ Make sure POWER switch on the front of CD changer is on.
¥ Make sure CD changerÕs power cord is plugged into the
back of the audio/video receiver.
¥ Make sure audio/video receiver is turned on.
CD changer is always turned on with
audio/video receiver
¥ This is how the system operates since the CD changer is
plugged into the back of the audio/video receiver.
Remote wonÕt control the audio/video
receiver, laserdisc player, CD Changer,
VCR, or satellite receiver
¥ Remove batteries for 2 minutes then reinstall the batteries
and try remote again.
¥ Maybe batteries are weak. Try new batteries.
To Next Page
Loading...
