RCA 3-DVD Changer - Remote Control Operation; Remote Control Overview

12
Remote Control Operation
ˆ
Remote Control Operation
A QUICK LOOK AT THE REMOTE CONTROL
OPERATING RANGE OF THE REMOTE
CONTROL
The remote control may not work properly if:
• There are obstacles between the remote control and the
receiver’s remote sensor.
• Direct sunlight or fluorescent light is shining onto the remote sen-
sor.
• The receiver is located near a device that is emitting infrared
rays.
• The receiver is operated simultaneously with another infrared
remote control.
BAND
– selects AM or FM band while listening to the
tuner function.
FM MODE
(FM MONO/STEREO) – selects FM
mono or stereo mode.
MEMORY
– Press to memorize the desired station
frequency.
TUNING MODE
– selects and deselects preset mode.
PRESET – / +
–- During AM or FM reception, you can
scan through other frequencies or select the preset
numbers.
MUTE
– Press to immediately decrease the sound lev-
el.
CKJ;
CKJ;CKJ;
CKJ;
appears on the display panel. To restore the
sound, press again.
SLEEP
– Press to set the sleep time. The
sleep time changes to
'&
'&'&
'&
,
(&
(&(&
(&
,
)&
)&)&
)&
, ...
/&
/&/&
/&
(minutes), and
E<<
E<<E<<
E<<
(former display).
TONE
– Lets you adjust the low frequency
level (BASS) with (left arrow icon) or (right ar-
row icon) and also you can adjust high fre-
quency level (TREBLE) with (left arrow icon)
or (right arrow icon) according to your taste
and room acoustics.
TEST TONE
– Turns on or off the test tone function in
DTS, DOLBY DIGITAL, or PRO LOGIC mode. The test
tone is output from Front L speaker, Center speaker,
Front R speaker, Surround R speaker, Surround L
speaker, (Subwoofer speaker: when Subwoofer on).
SURROUND
– When you select an analog
source (
TUNER
,
AUX
,
TAPE
,
TV
,
VCR
, or
SAT
), as you press
SURROUND
, the sur-
round mode changes.