1
Versión
en español
al dorso
AMPLIFIED
OUTDOOR/ATTIC HD ANTENNA
INSTALLATION GUIDE
ANT850E IB 03
What’s in the package?
(1) UHF element
(1) Antenna bracket
(5) M4x12 screws
(1) UHF/VHF combo box
(6) VHF element pieces
(1) Mounting base
(4) 1/4”x20 mounting screws
(1) Mast
(2) 1/4”x20 screws
(2) Hex Nuts
(2) Wing Nuts
(1) Clamp
(1) 16ft coaxial cable
(1) Amplier insert
BEFORE YOU START!!!
Please read the IMPORTANT SAFETY INFORMATION sheet included in this package.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed to this
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the radio or television off and on, the user is encouraged to try to correct interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on another circuit.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
Industry Canada Regulatory Information
CAN ICES-3 (B)/NMB-3 (B)
Avis d’Industrie Canada
CAN ICES-3 (B)/NMB-3 (B)
(1) Hardware bag
(1) M4x25 screw
To Next Page
Need help?
General
