Insert the cassette into the cassette
adapter.
(continued)
4. Gently close the cassette compartment
lid until it locks into place. Make sure
the cassette reel area under the adapter
is free to turn while the cassette is
loading.
Note: You should hear a whirring sound
while the tape loads. The adapter’s load
detector will automatically retract into the
adapter.
Caution:
If the jdqd detectqr is still
extending frani the side of the cassette
adapter z&r you ha,ve attempted to load
the cassette, the cas$$te loading is not
complete; Try to load the cassetie again.
Attempting‘to insert thi: ctiss#te’&-$er
into a VCR with the load de&t&
extending may ca&$ dtiage to the
cassette adapter and/or VCR.
Remove the cassette from the
cassette adapter.
Slide the adapter’s
EJECT
switch to
the right. The load detector will
extend from the side and the whirring
sound indicates the tape is being
released before the adapter’s cassette
compartment lid opens.
Use the access hole on the bottom of
the adapter to push the cassette up and
remove it from the adapter.
Gently close the adapter’s cassette
compartment lid.
23
To Next Page
Loading...
Need help?
General
