Picture is too dark
or subject too dark
Picture recorded
with special effect
Picture recorded in
brown tones
Picture recorded
with black bars at
top and bottom
Colors do not look
natural on recording
Picture blurred
during review or
camera edit
Date, time, and/or
age were recorded
on tape
Date, time, and/or
age are incorrect
Vertical white lines
appear when shoot-
ing bright object
Error number @I,
E02, etc.) appears in
viewfinder
l
For best results, only use higher shutter speeds outdoors.
Rotate SCENE SELECT AE dial to SPORTS. See page
l
Subject in front of a strong backlight. Rotate SCENE
SELECT AE dial to select B-LIT. See page 42.
l
Strong front spotlight on subject. Rotate SCENE
AE dial to select F-LIT. See page 42.
l
If at dusk or twilight, rotate SCENE SELECT AE dial to
select TWILIGHT. See page 42.
l
SCENE SELECT AE dial may be turned to special effect
mode. Turn the SCENE SELECT AE dial to OFF.
See page 42.
l
MONOCHROME selected with SCENE SELECT AE
Turn the SCENE SELECT AE dial to OFF. See page 42.
l
Camcorder is set to the 16x9 mode. Press the 16x9
See page 41.
l
Try adjusting white balance. See page 43.
l
Make sure tape speed SP/EP switch is set to the same
that the tape was recorded at.
l
Displays will be recorded on tape whenever they appear
the viewfinder. Press DISPLAY or AGE button to
them from viewfinder when recording. See pages 32-33.
l
When AUTO DATE or auto date titler mode is selected,
display will automatically be recorded when you begin
recording or change the cassette. See pages 32-33.
l
Clock lithium cell battery may need replacing. See page
l
Date, time, or age may need to be set. See pages 30-31.
l
This may occur when background extremely contrasts
the subject.
l
Try disconnecting power source. Wait ten seconds and
connect power source again. If error number does not
disappear from viewfinder, consult your Authorized
ct Camco&er Servicenter.
56
To Next Page
Loading...
Need help?
General
