Playback
Chapter 4 51
Removing the Tape from the Cassette
Tape Adapter
1. Slide the adapter’s EJECT switch to the right. The
load detector extends from the side and the
whirring sound indicates the tape is being
released before the adapter’s tape compartment
lid opens.
2. Use the access hole on the bottom of the
adapter to push the tape up and remove it from
the adapter.
3. Gently close the adapter’s tape compartment lid.
Caution: If the load detector is still extending
from the side of the cassette tape adapter after
you’ve attempted to load the tape, loading is not
complete. Try to load the tape again. Attempting
to insert the cassette tape adapter into a VCR with
the load detector extended may cause damage to
the adapter and/or VCR.
Caution: Do not touch the reels during loading
and unloading. It could cause injury or damage
the cassette tape adapter or tape.
Notes:
• During special-effect playback (still
frame, etc.), the picture may vibrate or
noise bars may appear on the screen.
• To record on a VCR using a compact tape
and the adapter, cover the adapter’s
recording safety hole with adhesive tape.
EJECT switch
To Next Page
Loading...
Need help?
General
