Advanced Features
58 Chapter 5
Factory Preset: Doesn’t display black bars.
Allows you to record black bars at the top and bottom of
the screen to produce a cinema-like wide-screen effect.
Allows you to set the tape length depending on the tape
used (see page 24).
Factory Preset: Make all of the icons appear on the LCD
monitor/viewfinder during playback or recording.
Make the following icons disappear from the LCD monitor/
viewfinder during recording or playback: cassette warning,
tape remaining time, battery pack remaining power icon
and tape length icon.
Refer to Animation and Time-Lapse (see pages 71-72).
Refer to Time-Lapse (see page 72).
Factory preset (OFF) : Usually the distance to a subject
where the lens is in focus depends on the zoom
magnification. Unless there is a distance of more than 1 m
(3.23 ft) to the subject, the lens is out of focus at the
maximum telephoto setting. When set to ON, you can
shoot a subject as large as possible at a distance of
approximately 60 cm (23-5/8¨).
Depending on the zoom position, the lens may go out of
focus.
16 x 9 OFF
ON
TAPE LENGTH
DISPLAY FULL
SIMPLE
REC TIME
INT. TIME
TELE MACRO OFF
ON
System Menu (continued)
To Next Page
Loading...
