RCA CC9360 - Dubbing to a VCR

Playback
Chapter 4 53
Dubbing to a VCR
1. Following the illustration in this chapter, connect the camcorder and the VCR.
2. Press in the Lock button while setting the camcorder’s Power switch to
, turn on
the VCR’s power, and insert the appropriate tapes in the camcorder and the VCR.
3. Make sure the VCR is in the appropriate AUX mode and the Record-Pause mode.
4. Use the camcorder’s Play mode to find a spot just before the edit-in point. Once it is
reached, press
/
on the camcorder.
5. When you’re ready to start recording, press
/
on the camcorder and press the
appropriate record button on the VCR.
6. When you want to stop recording, press the VCR’s pause button and press
/
on
the camcorder.
7. Repeat steps 4 through 6 for additional editing, then stop the VCR and camcorder
when finished.