Attach the Strap
Dropping a camera can _ause serious damage both
internally and externally. So, to secure your investment,
attach the hand strap first thing, and use it every time.
1. Insert the small loop at the end of the strap under the
strap eyelet.
2. Insert the other end of the strap through the loop to tie
the strap onto the strap eyelet.
Power Supply
Inserting the Hand Strap
This digital camera features two ways to supply power
to it; either use four batteries (size AA) or the included
AC adapter.
Inserting Batteries
The supplied AC adapter
1. On the bottom of the camera, slide the battery
chamber cover out in the direction of the large
arrow (as shown in the diagram to the right) to
open it. A click can be heard when the
compartment is released.
2. Insert four (4) AA batteries. Make sure to match
the positive and negative ends of the batteries to the
markings inside the battery compartment.
3. Close the battery chamber cover by pushing down flrrrdy and
sliding it back until the latch closes with a click.
The battery compartment
Important Notes!
• Never use manganese batteries.
• Your camera will not work if the batteries are inserted incorrectly.
• Remove batteries from camera if it will not be used for more than two
weeks.
• Never mix old batteries with new ones.
• Never mix batteries of different types.
• Never destroy batteries or dispose of in fire.This can cause an explosion
or leak caustic materials into the environment_
5
To Next Page
Loading...
Need help?
General
