Do you have a question about the RCA IP110 and is the answer not in the manual?
Number of Lines | 2 |
---|---|
VoIP Protocols | SIP |
Power over Ethernet (PoE) | Yes |
Speakerphone | Yes |
Headset Jack | Yes |
Lines | 2 |
Wall Mountable | Yes |
Handset | Yes |
Ethernet Ports | 2x 10/100 Mbps |
Display Size | 2.5 inches |
Introduces how to set up the phone with the packing list components.
Details how to connect the phone to the network and power sources.
Explains how to configure the phone using its embedded web server.
Describes DHCP and Static IP address configurations for the phone's network settings.
Details the parameters for registering to the SIP server using account data.
Explains how to perform configurations using the phone's keypad and requires admin privileges.
Describes the three modes for configuring the phone: User Mode, VAR mode, and Administrator Mode.
Details administrator access to phone configuration via web and phone interfaces, including password changes.
Explains how to adjust handset, speaker, headset, and ringer volumes in idle and active call modes.
Covers managing the phonebook, including adding, editing, deleting, and creating groups of contacts.
Details on assigning contacts to speed dial keys using the phone interface.
Steps for editing or deleting contacts from the phonebook via the phone interface.
Explains how to make outgoing calls using different call devices like handset, speaker, or headset.
Describes the icons and methods for selecting call devices.
Details various methods to initiate a call, including using line buttons, dialing, directory, call log, and speed dial.
Explains how to end an active call using the phone interface.
Steps to configure a button as a send key for immediate calling after dialing.
Instructions for setting a hot line number and delay for automatic dialing when off hook.
Steps to configure Caller ID restriction for outgoing calls using the phone interface.
Instructions to enable/disable anonymous call rejection via the phone interface.
Details how to answer an incoming call using handset, speaker, or headset.
Explains how to reject an incoming call directly using the MUTE/CANCEL key.
Explains how to mute/unmute the microphone during an active call.
Details how to place an active call on hold and retrieve it.
Instructions for performing a blind transfer without prior announcement.
Steps to perform an attended transfer with prior announcement.
Instructions for performing a semi-attended transfer.
Steps to establish a three-party conference call using the phone interface.
Lists parameters for advanced account settings accessible via the web interface.
Steps to reset the phone to factory default settings using the phone interface.
Instructions for manually updating the phone's firmware using the web interface.
Troubleshooting steps for server registration issues.
Troubleshooting steps for issues with obtaining an IP address.