24 Chapter 2 Using the remote control
How to Use Remote After Programming It
Once the remote has been programmed successfully, it is ready to operate your devices.
To operate a device:
1. Press the appropriate device button (SAT
/
AUX or DVD) to set the remote to control the
device, for example, press DVD to control your DVD player.
2. Press ON
•
OFF to turn the device ON or OFF.
3. Use the remote buttons that apply to that device.
Modes of Operation
The button corresponding to the mode the remote is in lights up when you press any button
that works in that mode. For example, if you’re in TV mode and you press the VOL+ button,
the TV button lights up. This tells you that the command to increase the volume is being sent
to the TV (and not the satellite receiver, for example).
Note: The remote
control may not be
compatible with all
brands and models
of devices.
To Next Page
Loading...
Need help?
General
