The AUX Button
OFF
BLINK
AUX CODE
10
1. Manually turn on the the device you wish to assign to
the AUX button (TV, VCR or Cable Box).
2. Press and hold the CODE SEARCH button until the
INDICATOR LIGHT lights, then release the CODE
SEARCH button.
3. Press and release the AUX button.
The INDICATOR LIGHT will blink.
4. Press TV, VCR or CAB (depending on which device
you wish to program). The INDICATOR LIGHT will
blink again then remain lit.
5. Find the three digit code for the device you wish to
program in the code list
Device Page
TV..............................4-5
VCR ..........................6-7
Cable Box ....................9
Enter the code using the Number Buttons.
After your code is entered, the INDICATOR LIGHT will
turn off.
6. Aim the remote at your device and press the POWER
button. Your device should turn off.
Note: If your device does not respond, try all the codes for your
brand. If the codes do not work, or your brand is not listed, try
the Code Search method on page 11.
7. With your device on, press CHANNEL UP. If the device
responds, no further programming is required.
8. Enter your code here for easy reference.
The AUX Button allows you to assign another TV, VCR or Cable Box to be controlled.
To Next Page
Loading...
Need help?
General
