4. Wait until the POWER key comes on and stays on. Then release both keys.
5. Look at the numbers you circled for your device’s brand code number. Press
those numbers on the remote keypad.
Note: For single-digit brand codes, press the 0 key first (e.g., 0-5 for 5).
6. Point the remote directly at the front panel of the device you want to
control. Press POWER on the remote and wait 2 seconds. The remote is testing
a single code for your device’s brand.
Did your device turn off?
YES: Press the STOP key to store the code. You’re done! You’ve
programmed this device key.
NO: Press POWER again. The remote tests the next code
for your brand.
Keep pressing POWER every 2 seconds until your device turns off.
When it does, press STOP.
Direct Code Entry
Direct Code Entry lets you enter a code from the accompanying code list for
your brand of device. It’s not as easy as the other methods, but it’s potentially
the fastest method.
To Next Page
Loading...
Need help?
General
