YES: You’re done! You’ve programmed this device key.
NO, it blinked four times and turned off: You have either entered a
code number that is not in the code lists or missed a step in the code
entry procedure. Try step 3 again.
Manual Code Search
The Manual Code Search lets you go one-by-one through all the codes for the
device you’re trying to control. When you find the one that operates your
device, you can stop the search and store that code.
1. Manually turn on the device you want to control.
TIPS: The Manual Code Search method may take a long time because the
remote searches through all of the codes in its memory one-by-one. If your
brand is listed in the Brand Codes or the Code Lists, first try the Brand Code
Search or the Direct Code Entry method.
Each device key is associated with a type of device—the TV is preset to search
for TVs, SAT•CBL•DTC for satellite receivers, cable boxes or digital TV
converters, and DVD•VCR for DVD players. To program the DVD•VCR key to
control a PVR or VCR, see the Reassigning the DVD•VCR Key to Control a
VCR section.
To exit without saving a new code at any point in the Manual Code Search,
press the EXIT key.
To Next Page
Loading...
Need help?
General
